The following Preventative Maintenance Items should be performed per the recommended schedule in order to maximize the life of your machine and to insure
warranty coverage. (For a checklist of all P.M. items, contact GCS or check the website.)
1. Lubricate bell shaped shaft seal and dispense valve o-rings following daily cleaning procedure.
2. Check bell shaped shaft seal for wear and replace when needed (every 1-6 months or more often if necessary). Seal is worn if edges that touch barrel
curl back.
3. Clean air filter weekly and condenser monthly or more often if necessary.
4. Check dispense valve o-rings for wear and replace as needed (every 3-6 months during complete PM or more often if necessary).
5. Perform complete PM every 3-6 months.
IMPORTANT-PREVENTATIVE MAINTENANCE
CLEANING CONDENSER
• Remove the back panel
• Using a dry brush or vacuum, remove the dust
that has accumulated between the fins of the
condenser
CHANGING LIGHT BULB
• To access the lightbulb insert the tip of a coin or
small screwdriver in the slot on the cover and
rotate to pop the panel open
• Holding the cover, carefully remove the lightbulb.
• Insert the new bulb and replace the light cover
REAR MERCHANDISER LIGHTS
• In order to access the lightbulb from the rear back
lit merchandiser, remove the rear merchandiser by
sliding it upwards.
• Then remove the lightbulb(s). Insert the new bulb(s).
• Reassemble the rear back-lit merchandiser making sure that its slots are
inserted properly in the relevant brackets.
REMOVING AND CLEANING THE FILTER IF EQUIPPED
(G & MG MODELS STANDARD; ID MODELS OPTIONAL)
In order to guarantee an efficient refrigerating system, it is
essential that the filter be properly cleaned, according to the
following procedures:
Attention: Failure to maintain a clean filter and condenser
will cause damage to the unit not covered by warranty.
• Unscrew the knob (K) on rear panel in order to have the
full back panel in your hands - (G, MG) on ID pull filter
cover from unit at bottom of cover, pull down to remove.
• Remove the filter (W) held inside the back panel (X) and
clean it properly using water or vacuum. Allow to dry.
• Put the clean dry filter back to its position and reinstall the back panel on
machine by screwing in the knob (K) or reattaching filter cover.
WARNING Disconnect the unit from its power supply prior to performing
any maintenance procedures. Failure to do so could result in electric
shock from hazardous parts or serious burns from hot surfaces.
!
a) Drip Tray - Black
90409
Drip Tray - White
90026
b) Drip Tray Grid - Black
90408
Drip Tray Grid - White
90025
c) Incandescent Light Bulb
90142
d) Knob to secure Bowl - Black
90426
Knob to secure Bowl - White
90024
e) Upper Mixing Bar
90065
f) Seal for Bowl
90023
g) Dispensing Valve Handle - Black
90401
Dispensing Valve Handle - White
90041
h) Handle Securing Pin - Black
90402
Handle Securing Pin - White
90042
i) Auger
90444
j) Spindle Bushing
90069
k) Shaft Seal, Rubber Bell Shaped - Black
90066
l) Securing Nut for Auger
90068
m)Dispensing Valve Spring
90044
n) Dispensing Valve Upper Body
90043
o) Food Grade Lubricant
90112
p) Dispensing Valve Lower Body -
90403
G & GM Series
Dispensing Valve Lower Body -
90045
ID Series
q) Dispensing Valve O-ring
90046
ITEM DESCRIPTION
PART NUMBER
ITEM DESCRIPTION
PART NUMBER
a
b
c
d
e
i
j
o
p
q
l
k
m
n
f
g
h
!
Key Replacement Parts
