PATERSON
BACK PANEL
Made in China - r3
Page 2 of 2
Customer Service
800.967.6696
|
Latest instructions available at
www.crateandbarrel.com
WALL
For added safety and stability, it is recommended that the wall mounting
hardware be installed. For safe mounting, it is essential to use wall
anchors appropriate to your wall type (i.e. plaster, drywall, concrete, etc.).
Mount to wood studs whenever possible.
A) Attach
anti-tip bracket
to top of
back panel assembly
using 2
small
screws
as shown.
B) Determine the final location of unit. Mark position on the wall,
approximately 2" below the anti-tip bracket mounted to the back of the
unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not available, drill a
hole in the wall that is slightly smaller in diameter than the anchor. Gently
tap the
plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach
wall bracket
to the wall by inserting 1
large screw
, and into
the plastic anchor in the wall.
E) Place the unit so the anti-tip bracket on the back edge is aligned with
the wall bracket on the wall.
F) Lace one end of the
wall strap
through both brackets, and into the
other end of the strap.
G) Pull the strap tightly until secure.
Wall mounting assembly is now complete.
NOTE: If you are unsure about
your wall type or what mounting
method you should use, consult
a qualified professional or your
local hardware store.
OPTIONAL WALL MOUNTING
INSTRUCTIONS
back panel
assembly
A
C
D
F
anti-tip
bracket
small
screw
wall
bracket
plastic
anchor
large
screw
wall
strap
