Before gluing the servos in place with a low temperature glue gun, bind them to the radio and center the servo arms
on the servo. Drill out the third hole in the servo with a 1/16" bit to be big enough for the push rod. Don't glue the
servo extension wires in except for where they exit the wing in the middle where they will be plugged into a Y
connector that plugs in the receiver.
Install the control horn in straight behind the servo arm with the holes in the control horn at the edge of the aileron.
cut a slit with a hobby knife. Make a small hole along the slit for glue to move up the horn and glue the horn in place
from both the top and the bottom.
Summary of Contents for Pelican Aileron Wing
Page 7: ......
