Crane RB-6913, Manual

Page: 8 / 12

7
ALWAYS use fresh cool water when operating the humidifier. Place
humidifier on a flat surface.
1.
Remove the top cover from the main body, fill water into water tank directly or
remove water tank from the base and fill with water and then replace into base. Do
NOT exceed the MAX level mark.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any essential oils, medication or salt to water tank or base.
2.
Attach Mist Chamber Cap on to top of the mist Chamber in the water tank.
3. Replace the cover onto the main body.
4.
Place top cover on humidifier base, making sure it fits together securely.
Caution: Do not attempt to move the humidifier while full Water. Doing so may cause
leakage of water.
5.
Plug the power cord into a wall socket and turn on the unit by using the Control Panel.
6.
Use the digital control panel or the remote control to adjust the mist output intensity
or to use the other features (see page 6).
SET THE CORRECT HUMIDITY OUTPUT: Adjust the Digital Control Panel so that the mist
rises up to be absorbed by the room air. Do not set the mist output too high, as the
mist cannot be absorbed by the air and may accumulate on the surfaces around the
humidifier.
REMOTE CONTROL
This humidifier includes a remote control to operate your device remotely. Simply pull
out the small plastic tab before use to activate. There are 12 buttons on the remote
and their function is equivalent to the functions of the touch sensors on the control
panel of the device. If you wish to use the remote control, point it at the approximate
level of the control panel with the display. The maximum signal range is 6 meters