Crane EE-5069, Manual

Page: 8 / 13

6
OPERATION & USE
OPERATING INSTRUCTIONS:
1. Power Button : Press to turn on and off the air purifier.
2. Fan Speed Button: Press to select speeds of I, II, III, or Turbo (Low, Medium,
High, and Turbo) All lights will illuminate on the Turbo setting.
NOTE: Air Purifier will start on Medium Speed when first powered on
1 Press: High 3 Press: Low
2 Press: Turbo 4 Press: Medium
3. UV/Sleep Button : Press to control UV Bulb and Sleep Mode. Press once to turn on
UV bulb, press twice for Sleep Mode, press three times to turn UV bulb off. Press
four times to de-activate Sleep Mode. In Sleep Mode the light blinks 10 times and all
indicator lights will go off. When the air purifier goes into sleep mode, the fan
setting automatically defaults to Low. To de-activate the sleep mode press any
button on the control panel.
NOTE: Once item is unplugged the sleep mode needs to be reset
4. Timer Button : Press to operate unit in intervals of 2 hours, 4 hours and 8 hours.
Press once for 2 hours, twice for 4 hours, and three times for 8 hours. The unit will
turn off when scheduled operating time has elapsed. To go back to a continuous run
time, press the button until there are no more indicator lights lit up.
5. Auto/Light Button: Press to control Auto Mode and Air Quality Indicator Light. In
Auto Mode, the purifier will automatically adjust based on the air quality in the room.
1 Press: Auto On 3 Press: Auto Off
2 Press: Light Off 4 Press: Light On
IMPORTANT NOTE:
When the unit is not in use, please turn the unit off and unplug
.
REPLACING THE HEPA FILTER
When the Filter Reset light is illuminated, it is an indication to replace the filter. Once
you have replaced the filter, hold the POWER button down for 5 seconds until unit beeps
to reset the system. On average, the HEPA Filter needs to be replaced every 3-6
months. Filter life will depend on air quality and usage.
1. ALWAYS turn off and unplug the air purifier from power outlet before replacing
the filter.
2. Unlock the base cover by sliding the base lock * and lift the top from the base.
3. Discard the old HEPA filter. DO NOT attempt to wash the HEPA filter.
4. Insert the new filter into the unit.
5. Once you have replaced the filter, replace the top onto the base and re-lock the
base cover. Hold the POWER button down for 5 seconds until it beeps, to reset
the filter indicator.
NOTE: Replacement HEPA Filter HS-1943 can be purchased online at www.crane-
usa.com .