11
Make sure the stationary members are in straight and that
the rubber ring is not out of it’s groove. Lightly oil
(DO NOT
use grease)
shaft and inner surface of bellows on rotating
member (46D) see Fig. 8. With lapped surface facing bearing
bracket (21), slide rotating member (46D) onto shaft, using
seal pusher, until lapped faces of (46D) and (46E) are together
(see Fig. 6).
It is extremely important to keep seal faces clean during
assembly. Dirt particles lodged between these faces will cause
the seal to leak.
Make sure driving lugs in retainer are matched in rotating
member. Place spring (46C) over shaft and in place on rotating
member (46E), making sure it is seated in retainer and not
cocked or resting on bellows tail. Re-oil shaft and lightly oil
inner surface of outboard rotating member (46B) With tail
section toward bearing bracket (21), slide rotating member
(46B) onto shaft with seal pusher until retainer engages spring
(46C) and spring is compressed slightly. Make sure spring
(46C) is properly engaged in both retainers. Insert O-ring (42)
onto bearing bracket (21). Slide seal plate (25) over shaft onto
bearing bracket (21), being careful not to damage outboard
stationary member (46A) and align holes for socket head cap
screws (39). Thread socket head cap screws (39) into bearing
bracket (21) and tighten. Fill seal chamber with oil as outlined
in paragraph F-1.3.
SECTION: G REPLACEMENT PARTS
G-1 ORDERING REPLACEMENT PARTS:
When ordering replacement parts, ALWAYS furnish the follow-
ing information:
1. Pump serial number and date code. (Paragraph G-4)
2. Pump model number. (Paragraph G-3)
3. Pump part number. (Paragraph G-2)
4. Part description.
5. Item part number.
6. Quantity required.
7. Shipping instructions.
8. Billing Instructions.
G-2 PART NUMBER:
The part number consists of a six (6) digit number, which ap-
pears in the catalog. A one or two letter suffi x may follow this
number to designate the design confi guration. This number is
used for ordering and obtaining information.
G-3 MODEL NUMBER:
This designation consists of numbers and letters which rep-
resent the discharge size, series, horsepower, motor phase
and voltage, speed and pump design. This number is used for
ordering and obtaining information.
G-4 SERIAL NUMBER:
The serial number block will consist of a six digit number,
which is specifi c to each pump and may be preceded by a al-
pha character, which indicates the plant location. This number
will also be suffi xed with a four digit number, which indicates
the date the unit was built (Date Code).
EXAMPLE: A012345
0490
.
Reference the six digit portion (Serial Number) of this number
when referring to the product.
FIGURE 8
Stationary Member (46A) &
(46E) Polished Face Out
Seal Plate (25) and
Bearing Bracket (21)
Seal Pusher
FIGURE 7
Rotating Member (46D)
Bullet
Motor & Bearing Bracket
Seal Pusher
Stationary
Summary of Contents for 6SED-L Series
Page 13: ...13 FIGURE 9 ...
Page 14: ...14 FIGURE 10 ...
