Crane Merchandising Systems Merchant 180, Operator'S Manual

Page: 161 / 170

Merchant™ Operators’ Guide Program:
1810006 153 January 2008
Programming: Security Codes
Enter Security Code
1. Press until you reach the Main
Menu , then use or to select
Security Codes and press .
2. In the Security Codes menu, use
or to select Enter Pin and
press .
NOTE
The factory default setting for the Supervisor
PIN code is 0000 . The Supervisor Mode grants
access to Main Menu selections that can be
programmed to not appear in the Main Menu
unless the Supervisor Mode is activated. To
change the Supervisor PIN code, see “Edit the
Supervisor PIN” on page 154.
3. Enter the Supervisor PIN code. The code
should be four digits. Be careful when
entering the PIN code – if you enter more
than four numbers, the display will scroll
back to the first digit.
4. Press to lock in the setting.
5. When a correct pin code is entered, the
screen will display Supervisor Approved
then cycle back to the Security Codes
menu. The respective menu(s) will be
accessible from the
Main Menu .
Proceed to:
a. The Main Menu by pressing .
-
or-
b. “Edit the Supervisor PIN” on page 154.
+
_
+
_
Main Menu
Product Configuration
5
Special Vend Modes
Free Vend
System Settings
Security Codes
6
Press EDIT to Select
Security Codes
Enter PIN
5
6
Press EDIT to Select
Enter Pin
0000
0-9 to Edit Value
EDIT when Finished
Enter Pin
Supervisor
Approved