TELL-ONE
CRAMARO TS S.r.l. – 37044 COLOGNA V.TA (VR), ITALY - VIA QUARI DESTRA, 71/G TEL. +39 0442/411688 / FAX + 39 0442/411690
E-MAIL [email protected] WEB : http://www.cramaro.com - Manual no. MTO001-EN-ED 02 – date 26/07/13
Page 15
3) ATTENTION: the tensioning of the spring must ONLY BE SUFFICIENT
to
completely wrap the
tarpaulin inside the housing. It must not be excessive because, if the spring is EXCESSIVELY
TENSIONED, the tarpaulin cannot be unrolled completely.
INSTRUCTION!
Whenever the tensioning of the spring is adjusted, it is mandatory to test the smoothness
and the proper rolling up of the tarpaulin in the housing.
4) If the spring is EXCESSIVELY TENSIONED it will be necessary to LOOSEN IT BY
INSERTING a flat-bladed screwdriver IN THE SLOT on the lower side of the “BOX“ located
on one of the two sides of the HOUSING (at one of the ends of the tarpaulin rolling up tube)
and CAREFULLY triggering the BLOCKING "TRIGGER" of the rolling up tube.
5)
After loosening the spring CHECK the correct wrapping of the tarpaulin again and, if needed,
gradually increase the tensioning of the spring as described in point 2.
Tarpaulin recall springs adjustment
Fig 9
ATTENTION
: >>>
HAZARD
<<<
When
UNLOADING the spring
do not forget to REMOVE THE WRENCH
from the PRELOAD NUT on the HOUSING
( + ) = greater load ( clockwise )
( - ) = smaller load ( unhooking )
