6.
off the unit (or take out the battery to recharge), landing it and wait the blades
completely stop turning as instructed earlier. Open the Camera Module/Battery Door then
disconnect the Battery from the Battery Connecting Plug.
7.
Turn
off the Remote Control, press the
Power On/Off Button to turn off the Remote
Control. The Power Indicator will not light.
BLADE(S) REPLACEMENT:
If any blade was damaged or deformed, replace it by the supplied same color of spare blade with
the supplied screwdriver as illustrated below:
Note: Always replace the damaged blade by the same color
of
blade. Otherwise, the motion of the
unit will become abnormal.
9
Turn
Gyroscope Reset
Before first flying , or if the drone is not stable flying after crash, or fell down on the
ground, you ahll to reset toe Gyroscope.
1. Pull the
Throttle
and
Rudder
down to 45 degree (Bottom Right corner as picture) for
2-3 seconds, the lights on the drone will blinking and you will hear 2 beep ‘Di-Di’, then
let go of the
Throttle
and
Rudder
, the lights on the drone will stop blinking.
then gyroscope reset complete.
6.
To
off the unit (or take out the battery to recharge), landing it and wait the blades
completely stop turning as instructed earlier. Open the
Battery Door then disconnect
the
Battery
from
the
Battery
Connecting
Plug.
7.
To turn off the Remote Control, press the Power On/Off Button to turn off the Remote
Control. The Power Indicator will not light.
GYROSCOPE RESET
BLADE(S) REPLACEMENT:
If any blade was damaged or deformed, replace it by the supplied same number(A or B) spare blade with
the supplied screwdriver as illustrated below:
9
Before first flying, or crash, or fell down quickly, or other action which make the drone flying
unstable,you need to reset the build-in Gyroscope as follows:
1. pull the left joystick and right joystick down to 45 degree (Bottom Right corner
as picture) for 2-3 seconds, the lights blinking quickly,and then the lights will stop blinking,
then release the two joystickst. and then gyroscope reset complete.
Note:Always replace the damaged blade by the same letter(A1 or B1) blade,or else, the motion of the
drone will become abnormal or cannot fly up at all(In fact, there are 2A and 2B on the drone, the two
blades(across corner)are same
（
A1=A2,B1=B2
)
.Do not mix them.
turn
LED light
A
A
B
B