DESCRIPTION cont.
14
ASSEMBLY & ADJUSTMENTS
The battery pack for this tool has been shipped in a low charge condition to prevent
possible problems.
Cutting Path
Speed
Rating
Line Diameter
Line Feed Mechanism
Power Head Tilt
Adjust Height of Shaft
Charger
Charge Time in Normal Use
Charger Number
Battery Pack Number
12 inches
8000 RPM
18.0 Volt
0.065-inch twisted line
Automatic
5 positions
From 17 to 28 inches
120V, 60Hz AC
3-5 hours
CGT184LU-23
CGT184LU-44 retail number 73083
SPECIFICATIONS
NOTE: The battery pack will not reach full charge capacity on the first few
charges. The break-in period requires 4 to 5 charging cycles, where the
battery pack is completely discharged (no motor sound or tool motion) and
then fully recharged. During the break-in period the battery pack needs to
charge 5 or more hours continuously. The green LED light on the charger
will come on in 3-5 hours, this is normal. Continue to leave the battery pack
charging for a total of 5 hours or more. After the break-in period, a full
recharge is indicated on the charger when the green LED light is lit.
CHARGING THE LITHIUM-ION BATTERY PACK (Fig. 3 and 3a)
1. Charge battery pack only with the charger that was supplied with this trimmer.
2. Make sure power supply to the charger is normal household voltage, 120 volts,
60 Hz, AC-only.
3. Connect the battery charger to the power supply and the green light will illuminate
showing charger is operating.
4. Slide the battery pack into the charger base to make the connections and the red
light will illuminate to show charging has started. The red light will stay lit until the
battery is fully charged.
ASSEMBLY & ADJUSTMENTS cont.
15
NOTE: Within the warranty period, if the charger LED lights do not operate
properly, or the charger does not charge the battery pack, return the
charger and battery pack to your nearest Sears Store or other Craftsman
outlet for free replacement.
NOTE: A hot battery pack only occurs when prolonged continuous use of
your trimmer causes the batteries to become hot. It does not occur with
typical use. Within the warranty period, if the battery pack becomes hot
with typical use, return the charger and battery pack to your nearest Sears
store or other Craftsman outlet for free replacement.
CHARGING THE LITHIUM-ION BATTERY PACK cont. (Fig. 3 and 3a)
CHARGING A HOT BATTERY PACK
7. The battery pack will become slightly warm to the touch while charging. This is
normal and does not indicate a problem.
8. Do not place the charger in an area of extreme heat or cold. It will work best at
normal room temperature.
9. When battery pack becomes fully charged, unplug battery charger from power
supply and remove the battery pack.
When using your tool continuously, the batteries in your battery pack will become
hot. You should let a hot battery pack cool down for approximately 30 minutes before
attempting to recharge.
Fig. 3
Fig. 3a
5. The red light will switch to green, which means the battery is full, and charging is
completed. A discharged battery at normal room temperature will take
approximately 5 hours to reach full charge. When charging is completed, unplug
the charger and remove the batter pack.
6. After normal use, 3-5 hour charging time is required to fully recharge the battery
pack. If battery pack has not been charged for two or more months or completely
discharged, then it should be charged continuously for 5 or more hours.
