4. Hanging Bracket Installation.
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to the
OFF position.
WARNING:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure the
outlet box is securely attached to the building structure and
can support the full weight of the fan. Ensure outlet box is
clearly marked "Suitable for Fan Support." If not, it must be
replaced with an approved outlet box. Failure to do so can
result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and that a
ground wire (
GREEN
or bare) is present.
Install hanging bracket to outlet box, using original screws,
spring washers and flat washers provided with new or
original outlet box.* If installing on a vaulted ceiling, face
opening of hanging bracket towards high point of ceiling.
Arrange electrical wiring around the back of the hanging
bracket and away from the bracket opening.
*
Note
: It is very important that you use the proper hardware
when installing the hanging bracket as this will support the
fan.
page 3
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 9 feet (2.74m) from the floor and
30in. (76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400
square feet (37.2 square meters).
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape
Vaulted ceiling
angle is not to
exceed 25 degrees.
downrod
installation
flushmount
installation
12f
t - 20f
t
12ft - 20ft
(3.66m - 6.1m)
9 feet
(2.74m)
(76cm)
30
inches
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing
a longer downrod (0.5in./1.27cm diameter).
Other installation, such as
flushmount
, is
not
available for this fan.
blade edge
(3.66m - 6.1m)
hanging bracket
spring washers
outlet box screws
flat washers
