20
21
20
21
WARNING
!
ADJUSTMENT INSTRUCTIONS
To avoid injury from an accidental
start, make sure the switch is in
the OFF position and the plug is
not connected to the power source
outlet.
BEVEL STOP ADJUSTMENT
(FIG. L, M, N)
To avoid injury from unexpected
starting or electrical shock, make
sure the trigger is released and
remove the power cord from the
power source.
90° Bevel Adjustment (Fig. L, M)
1. Loosen bevel lock handle (1) and
tilt the cutting arm completely to the
right. Tighten the bevel lock handle.
Lower blade.
2. Place a combination square (2) on
the miter table with the rule against
the table and the heel of the square
against the saw blade.
3. If the blade is not 90° square with
the miter table, loosen the bevel
lock handle, tilt the cutting head
completely to the left, loosen the
locknut (4) on the bevel angle
adjustment bolt (3) and use a
wrench to adjust the bolt (3) in or out
to increase or decrease the bevel
angle.
4. Tilt the cutting arm to back to the
right at 90° bevel and recheck for
alignment.
5. Repeat steps 1 through 4 if further
adjustment is needed.
6. Tighten bevel lock handle and
locknut (4) when alignment is
achieved.
WARNING
!
Fig. L
Fig.M
NOTE:
The upper blade guard has
been removed from this drawing
for illustration purposes only. Never
remove the upper blade guard.
90° Bevel Indicator (Fig. N)
1. When the blade is exactly 90° to
the table, loosen the bevel indicator
screw (5) using a #2 Phillips
screwdriver.
2. Adjust bevel indicator (6) to the
“0°” mark (7) on the bevel scale and
retighten the screw.
Fig. N
6
5
7
2
1
4
3
