7
ASSEMBLY
Wheel Assembly & Depth Stake Assembly
1.
Remove the remaining clevis pin and cotter pin from the manual bag, install
the wheel assembly into the chain case bracket as shown in Figure 3.
Figure 3
2.
Remove the two screws from the bracket in the chain case. See Figure 4.
Figure 4
3.
Insert the horizontal bracket into the chain case brackets and secure the
depth stake assembly in place with the screws just removed in step 1. See
Figure 4.
NOTE:
The depth stake can be placed at various positions. For setup purposes
it is suggested that the depth stake be assembled with the stake just above
or level with the ground surface. See the Operation section for instructions
on setting the tilling depth and adjusting the depth stake.
Handle
The handle is tilted down and packaged loose for shipping purposes. To attach the
handle, proceed as follows:
1.
Remove the bolts, washers and nuts from the chain case bracket. See Figure
5.
Figure 5
2.
Place the handle into position and secure with the previously removed
hardware. See Figure 5.
3.
Remove the handle adjustment crank from the handle. See Figure 6.
Figure 6
4.
Rotate the handle upward and secure it in place with the handle adjustment
crank. See Figure 6.
