REMOTE CONTROL
Your remote control has been programmed at the factory to
operate with your garage door opener.
Older remote controls are NOT compatible. Programming can be
done through the learn button on the garage door opener. If your
vehicle is equipped with a Homelink
®
, you may require an external
adapter depending on the make, model, and year of your vehicle.
Visit www.homelink.com for additional information.
TO ADD, REPROGRAM, OR CHANGE A REMOTE
CONTROL/WIRELESS KEYPAD PIN
1. Press and immediately release the Learn button.
2. Remote Control: Press and hold the button on the remote
control that you wish to use.
Wireless Keypad: Enter a 4-digit personal identification
number (PIN) of your choice on the wireless keypad. Then
press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard)
when the code has been programmed. Repeat the steps for
programming additional remote controls or wireless keypad devices.
“click”
“click”
1
2
LEARN LED
LEARN
Button
OR
PIN
?
?
?
?
4
GHI
5
JKL
7
PRS
8
TUV
9
WXY
0
QZ
*
#
ENTER
0
QZ
*
#
ENTER
6
MNO
TO ERASE THE MEMORY
ERASE ALL REMOTE CONTROLS AND WIRELESS
KEYPADS
1. Press and hold the LEARN button on garage door opener until
the learn LED goes out (approximately 6 seconds). All remote
control and wireless keypad codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES (INCLUDING myQ
®
ENABLED ACCESSORIES)
1. Press and hold the LEARN button on garage door opener until
the learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the LEARN button again until the
learn LED goes out. All codes are now erased. Reprogram
any accessory you wish to use.
ERASE THE CONNECTION FROM GARAGE DOOR
OPENER TO HOME Wi-Fi NETWORK
1. Press and hold the black adjustment button on the garage
door opener until 3 beeps are heard (Approximately 6
seconds).
36
