9
English
Installing And Removing Blade (Fig. G, H)
WARNING: To avoid injury from accidental
starting, always turn the switch OFF and remove
the plug from the power source before moving,
replacing, or adjusting the blade.
Removing (Fig. G, H)
1.
Loosen the blade tension by turning the blade tension
knob
1
counterclockwise. (Fig. G)
2. Open the upper wheel cover
15
and lower wheel
cover
12
by rotating the upper cover lock knob
3
and
lower cover lock knob
10
.
3. Remove the table aligning pad from the table.
4. Loosen the upper guide lock knob
25
on the rear side
of the band saw by turning it counterclockwise. (Fig. H)
5. Lower the upper blade guide
6
to its lowest position by
turning the blade guide height adjustment knob
4
.
6. Pull and open the blade guard
5
as shown in Fig. H.
7. Remove the blade
24
from the upper blade guide
6
and lower blade guide
9
.
8. Carefully pull the blade
24
from the table slot
27
and from the upper blade wheel
2
and lower blade
wheel
11
.
9. Hold the blade
24
, slide it out from the left side blade
guard slot
33
.
WARNING: Many illustrations in this manual
show only portions of the Band Saw. This is
international so that points being made in the
illustrations can be highlighted. Never operate
the saw without all guards securely in place and
in good operating condition.
ASSEMBLY AND ADJUSTMENTS
Estimated Assembly Time: 50 - 60 minutes
WARNING:
For your safety, never connect plug to
power source receptacle until all assembly and
adjustment steps are complete, and you have
read and understood the safety instructions.
Installing The Band Saw Table
(Fig. D, E, F)
1.
Bag "E" -
Loosen the table aligning bolt
8
and remove
the table aligning nut
26
from the table. (Fig. D)
2. Guide the table slot
27
over the saw blade
24
. (Fig. E)
3. Turn the scale pointer
28
down clockwise and place
the table by aligning the slot
29
of table tilt scale
22
with two pins
30
, then pull the table tilt adjustment
knob
21
out and the teeth of table tilt scale
22
engage
with the teeth of the table tilt adjustment knob
21
as
shown on Fig. F.
4.
Bag "D" -
Insert the table lock handle
19
through the
washer
31
and into the hole
32
, tighten the table lock
handle
19
.
5. Turn the scale pointer
28
back and tighten it with a hex
wrench. Adjust the table by aligning the zero scale mark
to the scale pointer
28
.
6. Replace the table aligning nut
26
back into the place
and tighten with the table aligning bolt
8
. (Fig. D)
8
26
Fig. D
Fig. E
24
27
Fig. F
22
29
21
32
31
28
19
30
Fig. G
1
15
12
3
10
