Craftsman CMEW020, Instruction Manual

Page: 8 / 48

English
6
Fig. F
3
19
13
3. Insert a M6 x 1 mm x 16 mm button head screw 16
through fence tilting bracket 15 and thread a M6 x 1
square nut 17 onto threaded end of screw 16 . DO NOT
COM PLETE LY TIGHTEN SCREW AT THIS TIME. Assemble
screw and square nut to opposite end of tilting bracket
in the same manner.
15
Fig. G
16
17
4. Slide groove of fence 18 over square nuts 17 .
Fig. H
18
17
5. Position fence 1 so that rounded section 45 on
bottom of fence is over cutterhead opening.
Fig. I
45
6. Tighten two screws 16 using included hex wrench.
Fig. J
16
Cutterhead Lock (Fig. K)
Assemble cutterhead lock
4
to the front side of the jointer
base, using the M6 x 1 mm x 12 mm button head screw 21 .
nOTE: The cutterhead lock is to be engaged with the
cutterhead shaft only when setting knives. All other
times, the cutterhead lock should be disengaged from
the cutterhead.
Fig. K
21
4