Attach Crossbars (B) to Front and Back of Table and to Left
and
Right Leg Panels:
•
Align the pre-drilled holes in Table with holes in Crossbar
• Partially tighten (6) M6x12 screws through each Crossbar
length.
length into Table.
•
Align Crossbar end holes with holes in Left and Right Legs.
• On each end of Crossbar, partially tighten (3) M6x12
screws through Crossbar holes into Leg holes as shown in
figure below.
Note: The Crossbar end flanges must be attached so that
they are on the outside of the Leg Panels.
Attach the Left and Right Leg Panels (C, D) to the
underside of the Workbench Table:
• Align the pre-drilled holes in Table with holes in top of
Legs.
• Partially tighten (5) M6x12 screws through each Leg into
Table as shown in the figure below. Tighten screws so
that Legs do not fall, but can be shifted for Crossbar
attachment.
Workbench
Back
A
C
Workbench
Front
D
ASSEMBLY
• Determine the front and back of table. Front has Craftsman
logo engraved in right corner. Leg Panels must be attached
to table with Back Rail attachment holes to the back of table.
• If not already done, place the table topside down onto
protective cardboard piece.
Items Needed:
Left Leg Panel (Qty: 1)
Workbench Wood Table (Qty: 1)
Right Leg Panel (Qty: 1)
M6x12 Screw (Qty: 10)
Items Needed:
Underside of Workbench Table
3
Left Leg Panel
(has Pegboard Holes)
Right Leg Panel
(has Power Strip
Opening)
B
B
Crossbar (Qty: 2)
M6x12 Screw (Qty: 24)
Table Front - Craftsman Logo Engraved on Top Side Right Corner
Table Back
