10
11
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the
battery pack will become hot. You should let a hot bat-
tery pack cool down for approximately 30 minutes before
attempting to recharge. When the battery pack becomes
discharged and is hot, this will cause the green LED to
come on instead of the red LED. After 30 minutes, reinsert
the battery pack in the charger. If the green LED continues
to remain on, return battery pack to your nearest Sears
Repair Center for checking or replacing.
NOTE:
This situation only occurs when continuous use
of the tool causes the batteries to become hot. It does
not occur under normal circumstances. Refer to
CHARG-
ING A COOL BATTERY PACK
for normal recharging
of batteries. If the charger does not charge your battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Sears Repair Center for
electrical check.
TO INSTALL BATTERY PACK
See Figure 5.
n
Place the lock-off button in the center position to lock
the switch.
n
Place the battery pack in the tool. Align raised rib on
battery pack with the groove inside the tool.
n
Slide the battery pack into the tool until the latches
on each side of the battery pack snap into place and
battery pack is secured in the tool before beginning
operation.
CAUTION:
When placing battery pack in the tool,
be sure raised rib on battery pack aligns with the
bottom of the drill and latches into place properly.
Improper installation of the battery pack can cause
damage to internal components.
TO REMOVE BATTERY PACK
See Figure 5.
n
Place the lock-off button in the center position to lock
the switch.
n
Locate latches on side of battery pack and depress to
release battery pack from the tool.
n
The battery pack will automatically disconnect when
buttons are depressed.
n
Remove the battery pack from the tool.
Fig. 4
�
�
GREEN
LED
YELLOW LED
RED LED
BATTERY PACK SHOWN IN CHARGER
BATTERY
PACK
LATCH
Fig. 5
