10
OPERATION
WARNING:
Do not allow familiarity with tools to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
WARNING:
Always wear safety goggles or safety
glasses with side shields when operating tools.
Failure to do so could result in objects being thrown
into your eyes, resulting in possible serious injury.
WARNING:
Do not use any attachments or acces-
sories not recommended by the manufacturer of
this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLIcATIONS
You may use this tool for the following purposes:
Drilling in wood
Drilling in ceramics, plastics, fiberglass, and laminates
Drilling in metals
Mixing paint
Hammer drilling in concrete, brick, or other masonry
This product will accept DieHard
®
19.2 V lithium-ion bat-
tery packs and Craftsman 19.2 V nickel-cadmium battery
packs.
For complete charging instructions, refer to the Operator’s
Manual for the battery packs and chargers listed in the
General Safety Rules.
TO INSTALL BATTERy PAcK
See Figure 3.
Lock the switch trigger by placing the direction of
rotation selector in the center position.
Place battery pack in the tool. Align raised rib on
battery pack with groove inside tool.
Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool
before beginning operation.
cAUTION:
When placing battery pack in the tool,
be sure raised rib on battery pack aligns with groove
inside tool and latches snap into place properly.
Improper assembly of battery pack can cause
damage to internal components.
TO REMOVE BATTERy PAcK
See Figure 3.
Lock the switch trigger by placing the direction of
rotation selector in the center position.
Locate latches on end of battery pack and depress to
release battery pack from the tool.
Remove battery pack.
Fig. 3
LATCHES
DEPRESS LATCHES
TO RELEASE BATTERY
PACK
