Side
Leveler
washer
Nut
Side
Front Rail
1.5"
(38 mm)
• Assemble (2) Screw Levelers in Side. Make sure both
Levelers are fully retracted in Side.
Bolt
Figure 2
Figure 1.1
Figure 1.2
3
asseMBLy
process:
• Ensure that the leveling screws on the existing
workbench are extended to at least (1.5) inch, (38 mm).
(See leveling foot adjustment.)
items needed:
Side (Qty:1)
Screw Leveler (Qty: 2)
items needed:
Front Rail (Qty: 1)
1/4-20 x 5/8″ carriage Bolt (Qty: 10)
5/16″ washer (Qty: 10)
1/4-20 Serrated Flange Nut (Qty: 10)
note:
when installing on 8' workbench, remove inner
support rails before installing side.
process:
note:
Drawer kit may be installed on left or right side.
Installation shown on right side.
• Install Side using (6) 1/4-20 x 5/8″ carriage Bolt, (6)
5/16″ washer, (6) 1/4-20 Serrated Flange Nut.
• Attach Front Rail, as shown, using (4) 1/4-20 x 5/8″
carriage Bolt, (4) 5/16″ washer, and (4) 1/4-20 Serrated
Flange Nut.
• Finger tighten.
• Adjust bench to desired height. (See leveling
foot adjustment.)
