FIG. 1
ASSEMBLY
THE MACHINE MUST NOT BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE 'OFF' POSITION UNTIL ASSEMBLY IS COMPLETE.
FIG. 2
1. Install the column onto the base using the
three column mounting bolts. FIG. 1.
2. If not pre-installed at the factory, install the
table lock handle through the unthreaded hole
on the left of the table support casting. The
handle should engage the thread on the right
side of the table support casting. FIG. 2.
NOTE: When loosening the table lock handle,
be sure to hold the table in place with your
other hand. This will prevent the table from
slipping down the column which may
damage
the
table or your workpiece.
Tools Required for Assembly
• Adjustable or 13mm Wrench
9
• Rubber Mallet or Hammer with Block of Wood
Parts Diagram and Parts List
are listed on pages 1
8
and 1
9
.
Replacement parts can be ordered by calling
1-8
88-331-4569
www.sears.com
FIG. 3
3. Slide the drill press head onto the column and
center the drill press head over the table and
base. FIG. 3.
