a.
Tuck wires back into the electrical box.
b.
Attach fixture to crossbar, making sure the insulation
material (if provided) stays between the ceiling and
the fixture. Attach lockwashers and nuts. Twist fixture
clockwise to lock screws into slotted holes in canopy.
Tighten nuts to secure fixture to ceiling.
c.
Install bulb(s) before adding glass. Use screw cap and
finial to secure globe to fixture, being careful not to
over-tighten as excess pressure may cause glass to
break.
Interior Lighting
Mount Indoor Fixture to Ceiling
Install bulb(s) before
adding globe. Use
Fitter Screws to hold
globe to fixture,
being careful not to
over-tighten as
excess pressure may
cause glass to break.
Fitter Screws
Glass Dome
Insulation
Material
For Fixtures
without Finial
Fixture Screws
Nut
Finial
Crossbar
Lockwasher
Glass Dome
Cap
Canopy
Wire Fixture to Outlet
Interior Lighting
Exterior Lighting
a.
Twist together white fixture wire with white outlet wire.
Next, twist together black fixture wire with black outlet
wire.
Use wire nuts (which should be included in your
junction box) to secure connections.
b.
Connect fixture ground wire (if provided) and outlet
ground wire to ground screw on crossbar as shown in
diagrams.
1
2
3
Wire Nuts
Ground Screw
Ground Wires
White Wires
Black Wires
Ground Screw
Black Wires
White Wires
Ground Wires
Wire Nuts
1
2
3
Crossbar
Mount Outdoor Fixture to Wall
Weep Hole
Bottom Finial
Weep Hole
Hex Nut
Short
Threaded
Nipple
Discard
Hex Nut
Remove
Attach
Long
Threaded
Nipple
Tail
Font Assembly
Bottom Finial
Remove bottom finial, font
assembly, short threaded nipple
(discard), and hex nut. Reattach
hex nut, then long threaded
nipple, tail, font assembly with
"weep hole" on bottom. Secure
with bottom finial as shown.
Adding Optional Tail Assembly
Wall Mount
Roof
Assembly
Screws
Cap Nuts
Roof
Bulb
Crossbar
a.
Tuck wires back into the electrical outlet box.
b.
Attach fixture to crossbar. Tighten cap nuts to hold fixture to
the wall.
c.
Remove roof assembly screws. Remove roof and insert bulb.
Reattach roof (see
Bulb Installation & Roof Assembly
section).
d.
To prevent moisture from entering the outlet box and causing a
short, use clear caulking to outline the outside of the fixture's
backplate where it meets the wall, leaving a space at the bottom to
allow moisture a means of escape.
e.
Photocell fixtures will automatically turn
on at sunset and turn off at sunrise.
Caulking
Backplate
Caulk
Glass Installation
Remove roof by unscrewing roof assembly
screws. Carefully install glass by sliding
glass panels into channel guides.