Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted
holes in fitter plate with loosened screws
in motor plate, allowing molex
connections from motor housing to come
through hole in middle of fitter plate. Twist
fitter plate to lock. Re-insert screw that
was just removed and securely tighten all
3 screws with a Phillips screwdriver.
Remove 3 screws from underside of fitter
plate.
Connect
WHITE
wire from LED light kit to
WHITE
wire from motor housing. Connect
BLACK
wire from LED light kit to
BLACK
(or
BLUE
) wire from motor housing. Be
sure that molex connections snap
together completely.
Carefully arrange wiring within fitter plate.
Align holes in LED light kit with holes in
fitter plate. Re-insert screws that were
previously removed and securely
tighten all 3 screws with a Phillips
screwdriver.
Align grooves on shade with nodules on
inside of fitter plate and push up gently on
shade. Twist shade to the RIGHT
(clockwise) until shade locks into place.
Pull down VERY GENTLY on shade to make
sure that shade is secure.
page 9
9. Light Kit Assembly.
motor housing
motor plate
fitter plate
LED light kit
molex
connections
motor housing
fitter plate
nodules
shade
grooves
