Step 1
Turn off circuit breakers and wall switch to the
fan supply line leads.
Warning:
Failure to disconnect power supply prior to
installation may result in serious injury or death.To
reduce the risk of shock, this fan must be installed with
an isolating wall control/switch.
1
4
OUTLET BOX
Outlet Box (A)
Mounting Bracket (1)
Bracket Screws
& Washers (S3)
Support Beam
Wood Screws (S1)
Canopy Screws (S2)
Ceiling
Wood Screws (S1)
“J” Hook (S10)
Step 3
Check to make sure blades are at
least 30” from any obstruction.
Check downrod length to
ensure blades are at least
7' above the floor.
3
84”
(2.1m)
Min.
30”
0.75m
Min.
Preparation
Important:
When using an existing outlet box, be sure the box is securely
attached to the building structure and can support the full weight of the fan.
Failure to do so can result in serious injury or death.
5
Step 2
Determine mounting method to use.
A. Downrod Mount
B. Angle Mount
Craftmade Part #45AD (see dealer)
2
IMPORTANT:
If using the angle mount
method, check to make sure the ceiling
angle is not steeper than 35°. Angles greater
than 35° will require a 45° angle adapter.
Downrod Installation
(Vaulted Ceilings)
Downrod Installation
(Normal Ceilings)
Step 4
Prior to securing mounting bracket, screw "J" hook (S10) into ceiling
outlet box as a secondary support means. Secure mounting bracket (#1)
to the outlet box (A) by tightening bracket screws & washers (S3) as
shown. If not mounting to an outlet box, use wood screws (S1) and
washers (S3) and mount securely to ceiling beam.
Be sure at this point
to insert canopy screws (S2) in bracket.
NOTE:
Do not mount directly to
sheet rock or ceiling tile.
NOTE: J Hook installation is a Canadian requirement only.
Flange
Cover
Hanging Ball
Downrod
Decorative
Downrod
Accessory
Lock Pin
Ball Screw
Green Ground
Wire
Downrod
Assembly
(#2)
Step 5
Locate downrod assembly
(#2). Loosen ball screw on
black hanging ball to free lock
pin. Black hanging ball will
slide down. Remove ground
screw and green ground wire.
Remove hanging ball from
downrod and save all parts.
Insert fan wires through
downrod. Screw Downrod
into top of fan motor housing,
being careful that wires are
pulled through. Slip Flange
Cover, Decorative Downrod
Accessory and Canopy over
the Downrod.
Fan Motor Housing
