page 6
7. Canopy Assembly.
6. Wiring. (cont.)
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed, and then tighten both screws
securely. Slide canopy cover up to canopy,
aligning rounded part of slotted holes in canopy
cover with screw heads in bottom of canopy.
Turn cover to the right (clockwise) until it stops.
*Remember that antenna for remote control
receiver must rest
outside
of hanging bracket.
canopy
hanging bracket
screw
receiver
screw
antenna
IN ORDER TO WIRE WALL CONTROL
, remove existing
wall switch. Wire the
WALL CONTROL
with wire
connectors provided
as shown in
diagram at right.
* Wrap each wire connector separately with electrical
tape as an extra safety measure. Gently push wires and
taped wire connectors into outlet box.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 on the wall control. Factory
setting is pre-set and not recommended for use.
Write
down the number sequence to use in Section 10.
Note
: The dimmer switch (labeled
D
and
X
) has been
pre-set to the "ON" position (
D
). If you do not wish to
have dimming capability, please move the switch to
the "OFF" position (
X
).
Install one 12-volt battery (included) in wall control.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front plate to
wall control using 2 screws provided in the wall
control.
Important
: Wall control will not function unless
battery is installed.
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
(wiring for wall control)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall
control
plate
code
switches
12V battery
dimmer
switch
1 2 3 4 X
D
1
1
-
2
2
-
canopy cover
