5. Fan Assembly.
NOTE
: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this fan.
page 5
downrod
electrical wiring
canopy
yoke cover
motor
housing
Remove hanging ball from downrod provided
by loosening set screw on hanging ball. Remove
pin and clip. Lower hanging ball and remove
stop pin. Then slide hanging ball off downrod.
[
Refer to
diagram 1
.
]
Loosen yoke set screws and nut at top of motor
housing.
[
Refer to
diagram 2
.
]
Tip
: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
[
Refer to
diagram 2
.
]
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire
slack from the upper end of the downrod.
[
Refer
to
diagram 2
.
]
Thread downrod into the motor housing yoke
until holes for pin and clip in downrod align with
holes in yoke--
make sure wires do not get
twisted
. Re-insert pin and clip that were
previously removed. Tighten yoke set screws
and nuts securely.
[
Refer to
diagram 2
.
]
Slide yoke cover and canopy over downrod.
[
Refer to
diagram 3
.
]
Thread safety cable and wires through hanging
ball; then slide hanging ball over downrod--the
top of the downrod should be noted as having a
set screw hole; use this hole when setting the set
screw. Insert stop pin into top of downrod and
raise hanging ball. Be sure stop pin aligns with
slots on the inside of the hanging ball. Tighten
set screw securely.
[
Refer to
diagram 4
.
]
WARNING
: Failure to tighten set screw (on
hanging ball) completely could result in the
fan becoming loose and possibly falling.
["Fan Assembly" continued on next page.]
diagram 2
diagram 1
diagram 3
diagram 4
set screw hole
hanging ball
stop pin
set screw
hanging ball
stop pin
pin
clip
downrod
electrical wiring
yoke set screw
and nut
pin
clip
motor
housing
safety cable
