page 8
8. Blade Assembly.
fitter plate
molex connections
motor plate
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
connections from motor housing to come through
hole in middle of fitter plate--remove and discard
plastic that holds these 2 wires together. Twist fitter
plate to lock. Re-insert screw that was just removed
and securely tighten all 3 screws with Phillips
screwdriver.
Connect WHITE wire from motor housing to WHITE
wire from LED light kit. Connect BLACK (or BLUE)
wire from motor housing to BLACK wire from LED
light kit. [NOTE: It may be necessary to push back
sleeve on wires to be certain of wire colors.] Be sure
molex connections snap together securely.
Remove 1 screw from underside of fitter plate and
partially loosen the other 2 screws.
Carefully arrange wiring within fitter plate. Align
slotted holes in LED light kit with loosened screws in
fitter plate. Twist LED light kit to lock. Re-insert screw
that was previously removed and tighten all 3 screws
securely.
["Light Kit Assembly" continued on next page.]
motor
housing
WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
screws are overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 9 blade attachment screws and washers and
9 decorative nuts in one of the hardware packs. Place
blade arm on UNDERSIDE of blade, aligning holes in
blade arm with holes in blade as shown. Insert
3 decoratvie nuts into holes in blade from UNDERSIDE
of blade (i.e., the side that will face the floor), making sure
to completely insert each decorative nut so that the
blade arm can be attached correctly. Insert 3 blade
attachment screws/washers) from TOPSIDE of blade
with fingers first and then tighten screws securely with
a Phillips screwdriver. Repeat procedure for remaining
blades.
Remove blade arm screws/lock washers from fan motor
and set aside. [WARNING: Do NOT remove the 4 screws
located on the outer rim of the underside of the motor
housing--doing so or any attempt at doing so will void
the warranty.] Align blade arm holes with motor screw
holes and attach blade arm with blade arm screws/lock
washers. Before securing screws permanently, repeat
this procedure with remaining blade arms. Secure all
screws.
NOTE: Tighten blade arm screws twice a year.
motor
housing
blade
decorative
nuts
blade arm
blade attachment
screws/washers
blade arm
screws/
lock washers
LED light kit
molex
connections
fitter plate
