page 7
reverse switch
9. Testing Your Fan.
It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with pull chain. (
diagram 1
) Start at the OFF
position (no blade movement). First pull will set
the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth
pull will again set the fan to the OFF setting. If fan
does not function, please refer to
"Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important
: Reverse switch must be set either
completely DOWN
or
completely UP
for fan to
function. If the reverse switch is set in the
middle
position (
diagram 4
), fan will not operate.
NOTE
: Do NOT remove weatherproof cover from
reverse switch.
Attach pull chain extension supplied or custom
pull chain extension (sold separately) to the end of
the pull chain.
diagram 1
diagram 1
diagram 2
diagram 3
pull chain
extension
