page 7
7. Canopy Assembly.
8. Blade Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both
screws securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
WARNING
: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades. If overtightened, blades
may crack and break.
Locate 9 blade attachment screws/washers
in hardware pack. Place blade arm on
TOPSIDE
of blade and blade plate
UNDERNEATH
the blade, aligning holes in
blade plate, blade and blade arm, as shown.
(Be sure to install blades with ridged-side
facing down and flat side facing the ceiling).
Insert 3 blade attachment screws/washers,
with fingers first and then tighten screws
securely with a Phillips screwdriver.
Repeat
for the remaining blades.
Remove blade arm screws/lock washers
from underside of motor. Align blade arm
holes with motor screw holes and attach
blade arm with blade arm screws/lock
washers. Before securing screws
permanently, repeat procedure with
remaining blade arms. Securely tighten all
screws.
Note
: Tighten blade attachment screws
twice a year.
blade arm
screws/washers
hanging
bracket
canopy
screw
screw
canopy cover
blade
blade
blade attachment
screws/washers
blade plate
blade arm
