page 8
9. Light Kit Assembly.
light kit fitter
molex
connections
glass shade
bulb
fitter plate
molex connections
motor plate
blade
motor housing
Remove 1 screw from motor plate on
underside of motor housing and partially
loosen the other 2 screws. Align slotted holes in
center of fitter plate with loosened screws in
motor plate, allowing molex connections from
motor housing to come through hole in middle
of fitter plate. Twist fitter plate to lock. Re-insert
screw that was previously removed and
securely tighten all 3 screws with Phillips
screwdriver.
Remove 1 screw from underside of fitter plate
and partially loosen the other 2 screws.
Connect
WHITE
wire from motor housing to
WHITE
wire from light kit fitter. Connect
BLACK
wire from motor housing to
BLACK
wire from
light kit fitter. Be sure molex connections snap
together securely.
Align slotted holes in light kit fitter with
loosened screws in fitter plate. Twist light kit
fitter to lock. Re-insert screw that was
previously removed and tighten all 3 screws
securely.
Install two 50 watt max. halogen bulbs, type JD
E11 (included).
Important
: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
Tip
:
Do not touch glass portion of bulb with
fingers or hands. Oil from skin can cause bulb to
overheat and go out prematurely. Use cardboard
box or foam wrapping bulb was packed with to
layer around glass portion of bulb.
Align grooves on glass shade with nodules on
inside of fitter plate and push up gently on
glass shade. Twist glass shade to the RIGHT
(clockwise) until glass shade locks into place.
Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
blade
motor housing
fitter plate
nodule
slot
