page 9
grooves
dimmer
switch
wall control
wire
wire
wire
12V battery
10. Handheld Remote Control Assembly.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10
for remote control assembly instructions. If you
have already installed the wall control but do
not
wish to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts.
[
Refer to
diagram 1
.
]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible.
[
Refer to
diagram 2
.
]
Install one 12-volt battery (included) in wall
control.
[
Refer to
diagram 2
.
]
The dimmer switch (labeled
ON
and
D
) has
been pre-set to the "ON" position (
ON
). If you
do not wish to have dimming capability, please
move the switch to the "OFF" position (
D
).
[
Refer
to
diagram 2
.
]
Align holes in wall control with posts located
on
inside
of TOP part of remote control cover
and press together firmly. Place wall control into
BOTTOM part of remote control cover, aligning
posts in top of remote control cover with post
holes in the bottom.
[
Refer to
diagram 3
on the
next page.
]
[”Handheld Remote Control Assembly"
continued on next page.]
(top)
(bottom)
remote control
cover
diagram 1
diagram 2
I
I I
IV
VI
I I I
V
9. LED Light Kit Assembly. (cont.)
If you do NOT wish to use the light kit
,
locate
slots on metal cover and align with nodules
inside
LED light kit
. Gently push up on metal
cover and turn to the
RIGHT (clockwise)
until it
no longer turns.
WARNING
: Metal cover will be HOT if light is left
on.
metal
cover
nodules
