page 6
5. Fan Assembly (with downrod). (cont.)
hanging ball slot
hanging bracket tab
With the hanging bracket secured to the outlet box
and able to support the fan, you are now ready to hang
your fan. Grab the fan firmly with two hands. Slide
downrod through opening in hanging bracket and let
hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging
bracket tab.
WARNING: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or
death.
Tip: Seek the help of another person to hold the
stepladder in place and to help lift the fan up to you
once you are set on the ladder.
Continue to "Wiring" section on page 7 for wiring
diagram.
6. Fan Assembly (flushmount).
Remove and set aside canopy cover to
reveal 6 holes.
[Refer to diagram 1.]
Notice
that 3 of these holes are larger.
If there are only 3 screws in top of motor
housing, please proceed to next paragraph.
If there are 6 screws in top of motor housing,
remove every other screw and lock washer.
Thread wiring through canopy. Place canopy
over yoke, aligning larger holes in canopy
with the 3 existing screws in top of motor
housing. Insert the 3 screws and 3 lock
washers that had been removed (if there
were only 3 screws located in top of motor
housing, these screws/lock washers will be
located in one of the hardware packs) into
the remaining holes. Securely tighten these
screws.
[Refer to diagram 2.]
To prepare the fan for wiring, hang fan
onto hanging bracket by sliding the
canopy over the hanging bracket tab.
[Refer
to diagram 3.]
(Use one of the non-slotted
holes on the rim of the canopy to do so.)
canopy
canopy cover
canopy
motor housing
yoke
diagram 1
motor
housing
canopy
motor
housing
hanging
bracket tab
diagram 2
diagram 3
