page 9
10. Light Kit Assembly. (cont.)
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light switch (if
applicable). Test fan speeds with the pull chain on the switch
housing. Start at the OFF position (no blade movement). First
pull will set the fan to HI. Second pull will set the fan to
MEDIUM. Third pull will set the fan to LOW. Fourth pull will
again set the fan to the OFF setting. Test light with the pull
chain in the middle. (
diagram 1
) If fan and/or light do (does)
not function, please refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse switch. Set
reverse switch to recirculate air depending on the season:
- DOWN position in summer (
diagram 2
)
- UP position in winter (
diagram 3
)
A ceiling fan will allow you to raise your thermostat setting in
summer and lower your thermostat setting in winter without
feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely UP
or
completely DOWN
for fan to function. If the reverse switch is
set in the
middle
position (
diagram 4
), fan will not operate.
Attach pull chain extension(s) supplied or custom pull chain
extension(s) (sold separately) to end(s) of the pull chain(s).
11. Testing Your Fan.
Connect
WHITE
wire from switch housing to
WHITE
wire
from light kit fitter. Connect
BLACK
(or
BLUE
) wire from
switch housing to
BLACK
wire from light kit fitter. Be sure
molex connections snap together completely.
Align holes in light kit fitter with holes in switch housing.
[
Note
: The gap on the top edge of the switch housing cap
must align with the reverse switch on the switch housing
for the proper fit.] Attach light kit fitter with screws that
were removed on previous page. Securely tighten all
3 screws with a Phillips screwdriver.
Install 3 candelabra base 40 watt max. bulbs (included).
IMPORTANT
: When you need to replace bulbs, please
allow bulbs and glass shade to cool down before handling.
Remove finial, finial plate, hex nut, flat washer and rubber
washer from threaded rod at bottom of light kit fitter.
Place rubber washer inside glass shade over center hole.
Raise glass shade in order to guide pull chains through
appropriate holes in glass shade. Align threaded rod on
light kit fitter with hole in middle of glass shade and push
up gently, allowing threaded rod to come through hole.
(
Be sure pull chain for fan operation does not rub against
bulb during operation.
)
Replace flat washer and hex nut on threaded rod. Tighten
hex nut to secure glass shade, but
DO NOT OVERTIGHTEN
hex nut as glass may crack or break.
Align hole in center of
finial plate with threaded rod, allowing pull chains to come
through appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial and secure
glass shade to light kit fitter by tightening finial.
DO NOT
overtighten finial as glass may crack or break.
motor housing
glass
shade
finial
bulb
light kit fitter
switch
housing
pull chain
extensions
pull chain
for fan
reverse
switch
pull chain
for light
finial plate
black
wire
black
(or blue)
wire
white
wire
molex
connections
flat washer
hex nut
rubber washer
diagram 2
diagram 3
diagram 4
diagram 1
white
wire
