page 12
motor
housing
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test wall control (optional
installation) by locating ON/OFF slider switch on wall
control, then set to the ON position. Test light and
dimmer function and then test fan speeds. Next,
locate handheld remote control. Test the light
ON/OFF function by pressing the L1 button; test
the dimmer function by pressing the L1 button and
holding it down for up to 5 seconds. Test fan speeds
with the different fan speed buttons. If the wall
and/or handheld remote control operate(s) all of the
functions of the fan and light, battery/batteries has
(have) been installed correctly. If the wall and/or
handheld remote control do (does) not operate all
of the fan/light functions, refer to "Troubleshooting"
section to solve any issues before contacting
Customer Service.
Fan must be on LOW before setting the fan to reverse
direction. Use "reverse" button (REV) to recirculate
air depending on the season.
NOTE
: If the wall control/handheld remote control
interferes with other appliances,
turn power off first
and then go back to the instructions in Section 12
(page 11).
15. Testing Your Fan.
14. Smart Ceiling Fan Wi-Fi Control. (cont.)
(Optional)
8
. Test the fan functions:
- You have the option to disable the light function if your fan does not have a light.
9
. Select “
YES, IT WORKS
.”
10
. Specific information about your fan:
-Select “
Location
” and choose from one of the predefined entries or add your own by selecting
“
OTHER
”. When finished, select “
Save
”.
- Select device name and enter the name for your device. When finished, select “
OK
” to save.
PLEASE NOTE
: This name will be used for integrations so a simple, easy-to-remember name is best.
11
. Select “
Continue
”.
12
. Select the Wi-Fi network you would like to connect the SBB to.
13
. Enter the Wi-Fi password and select “
OK
”.
14
. If there is an issue with the connection or wrong password is entered, you will receive an error message.
Select “
OK, I’ve Got It
”.
15
. Once the connection is made, select “
DONE
”.
16
. If the SBB fan is not displayed in the Bond application, swipe down to refresh.
For assistance at any time during this process, go to the “
Help
” section of the app:
- Tap on “
Settings
”
- Tap on “
Help Center
”
- Choose “
Open a Ticket
” or “
Live Chat
”
diagram 1
diagram 2
diagram 3
1
1
-
2
2
-
1
1
-
2
2
-
