Top Pole
Decorative
Sleeve
Coupler
Allen Wrench
Bottom Pole
Decorative
Bottom
Base
Stake
TH003 Thermometer Assembly
Parts:
TEMPERATURE
F
120
100
80
60
40
20
0
-20
-40
-60
HUMIDITY
%
100
90
80
70
60
50
40
30
20
10
0
Stake
4 Pcs.
Bottom
Pole
1 Pc.
Bottom
Decorative
Piece
1 Pc.
Top Pole with
Mounting
Bracket
1 Pc.
Thin Pipe
1 Pc.
Large Pipe
1 Pc.
EW Vane
1 Pc.
Vane
1 Pc.
NS Vane
1 Pc.
Allen Wrench
1 Pc.
Base
1 Pc.
Decorative
Sleeve
1 Pc.
Foot tab
4 Pcs.
Coupler
1 Pc.
Ball
1 Pc.
Display Head
1 Pc.
ASSEMBLY:
Time: 20-30 minutes
Tools: Screwdriver, Hammer
1) Base can be installed with adjustable screw-in foot tabs to stand on hard surfaces, stakes for
insertion into grass/soil surfaces, lag bolts for cement surfaces or wood screws for deck installa-
tion. Thread foot tabs or stakes into the four holes under base. If foot tabs are used, adjust height
as necessary leveling fixture for uneven surfaces. If stakes are used, find level, firm grass/soil
area for inserting stakes. If lag screws are used, insert lag screw and secure top portion onto base
using lock washer, washer and hex nut. If wood screws are used, screw firmly onto level wood
surface. Plug hole where screws were inserted with Hole Cover.
2) Attach decorative bottom to base. Next, attach bottom pole to base.
3) Slide decorative coupler onto bottom pole and slowly slide down to top of Decorative Bottom. (Do
not yet secure).
4) Thread top pole with mounting bracket to bottom pole. (If necessary, adjust height of bracket by
loosening screws and moving bracket to height desired and re-tightening screws.)
5) Slide decorative coupler back up to center of entire pole, so it covers the seam between top and
bottom poles. Using the provided Allen wrench, tighten threaded nipple embedded inside coupler
until coupler is tight and secure.
Hex Nut
3 Pcs
Washer
3 Pcs
Lock Washer
3 Pcs
Lag Bolt
3 Pcs
Wood
Screw
3 Pcs
Hole Covers
3 Pcs
6) Mount display head to pole by
first sliding one end of bracket
through open-ended sleeve on
back of head. Then slide head
back in opposite direction, so
other end of bracket slides
through close-end sleeve.
7) Attach decorative bottom to
base. Next attached bottom
pole to base. After display
head is centered on the
brackets, secure display head
to pole by tightly threading
thumbscrews onto bracket.
8) Slide NS Vane (with imbedded
nipple) over top pole above
display head and secure it
to top of pole by tightening
imbedded nipple with Allen
wrench. Slide EW vane over
pole, so it rests on NS Vane.
9) Thread thin pipe onto top pole
and then slide large pipe over
thin pipe.
10) Slide remaining vane and ball
over pipe.
Foot
tab
Wood Deck Installation
Cement Installation
Steps 1-5
E1
E2