3
SAFETY INSTRUCTIONS
(cont.)
5.
KEEP VISITORS AND CHILDREN AWAY. DO NOT
permit people to be in the immediate work area,
especially when the electrical tool is operating.
6.
DO NOT FORCE THE TOOL
to perform an opera-
tion for which it was not designed. It will do a safer
and higher quality job by only performing operations
for which the tool was intended.
7.
WEAR PROPER CLOTHING. DO NOT
wear loose
clothing, gloves, neckties, or jewelry. These items
can get caught in the machine during operations
and pull the operator into the moving parts. The
user must wear a protective cover on their hair, if
the hair is long, to prevent it from contacting any
moving parts.
8.
ALWAYS WEAR EYE PROTECTION.
Any power
tool can throw debris into the eyes during opera-
tions, which could cause severe and permanent
eye damage.
ALWAYS
wear Safety Goggles
when operating power tools.
9.
WEAR A DUST MASK TO PREVENT INHALING
DANGEROUS DUST OR PARTICLES
.
10.
ALWAYS UNPLUG THE TOOL FROM THE ELEC-
TRICAL RECEPTACLE
when making adjustments,
changing parts or performing any maintenance.
11.
KEEP PROTECTIVE GUARDS IN PLACE AND IN
WORKING ORDER.
12.
AVOID ACCIDENTAL STARTING.
Make sure
that the power switch is in the “OFF” position
before plugging in the power cord to the electrical
receptacle.
13.
REMOVE ALL MAINTENANCE TOOLS
from the
immediate area prior to turning the tool “ON”.
14.
USE ONLY RECOMMENDED ACCESSORIES
.
Use of incorrect or improper accessories could
cause serious injury to the operator and cause
damage to the tool. If in doubt, check the instruction
manual that comes with that particular accessory.
15.
NEVER LEAVE A RUNNING TOOL UNATTEND-
ED.
Turn the power switch to the “OFF” position.
DO NOT
leave the tool until it has come to a
complete stop.
16.
DO NOT STAND ON A TOOL.
Serious injury could
result if the tool tips over or you accidentally contact
the tool.
17.
DO NOT
store anything above or near the tool
where anyone might try to stand on the tool to
reach it.
18.
MAINTAIN YOUR BALANCE. DO NOT
extend
yourself over the tool. Wear oil resistant rubber-
soled shoes. Keep floor clear of debris, grease
and wax.
19.
MAINTAIN TOOLS WITH CARE
. Always keep tools
clean and in good working order. Keep all blades
and tool bits sharp.
20.
EACH AND EVERY TIME, CHECK FOR DAM-
AGED PARTS PRIOR TO USING THE TOOL
.
Carefully check all guards to see that they operate
properly, are not damaged, and perform their
intended functions. Check for alignment, binding or
breaking of moving parts. A guard or other part that
is damaged should be immediately repaired or
replaced.
21.
DO NOT OPERATE TOOL IF UNDER THE
INFLUENCE OF DRUGS OR ALCOHOL.
22.
SECURE ALL WORK.
When it is possible, use
clamps or jigs to secure the workpiece. This is safer
than attempting to hold the workpiece with your
hands.
23.
STAY ALERT, WATCH WHAT YOU ARE DOING,
AND USE COMMON SENSE WHEN OPERATING
A POWER TOOL. DO NOT USE A TOOL WHILE
TIRED OR UNDER THE INFLUENCE OF DRUGS,
ALCOHOL, OR MEDICATION
. A moment of in-
attention while operating power tools may result in
serious personal injury.
This Tenoning Jig is for indoor use only. Do not expose
to rain or use in damp locations.
WARNING
!
This jig should only be used with suitable tablesaws.
Please refer to your tablesaw’s manual for further
information. All tablesaw safety features and guards
must be kept in place and in good working order
during the use of this jig.