13
TABLE HEIGHT
ADJUSTMENT
The table on CX505 can be adjusted to
different heights. Table height adjustment
allows using different portions of the
sanding belt surface while sanding and
results in even wearing of the sanding belt.
The belt on CX505 is 6” in width. When
sanding a 3” tall work-piece, for the first half
you can adjust the table height and use the
lower portion of the sanding belt while for
the second half you can adjust the table
using the upper portion of the sanding belt.
This maximizes the sanding belt usage on
you sander.
To adjust the table height:
Loosen the two lock knobs shown in figure-
14 and lower or raise the table to your
desired height. Tighten the knobs and lock
the table in position.
Figure-14 Table height lock knobs
TILTING THE SANDING
HEAD
The sanding head can be adjusted to any
angle from 90° to 180° as required for your
job.
To tilt the sanding head:
Unlock the sanding head by loosening the
lock lever under the head shown in figure-
15. Tilt the head to the required angle on
the head tilt scale.
Figure-15 Sanding head tilt scale
Once the sanding head is in the desired
angle, pull the lock lever and secure the
head in position.
WARNING!
Make sure the machine’s power switch is
off and the cord is disconnected from the
power source when installing/removing
any part or servicing the sander.
WARNING!
Make sure to lock the dust hood in
position before tilting the sanding head
so that the dust hood does not scratch
the body of the sander.