Craftex Ct169, User Manual, Page: 10 / 15

10
DUST PORT
CT169 features a 1-1/8” dust port located
under the rollers. When connecting to a
dust collector, use a proper sized hose and
make sure all the connections are tightly
sealed.
Figure-6 Dust port
SANDING ARM ANGLE
The sanding arm can be tilted through 90°
from horizontal to a vertical position.
To move the sanding arm to the desired
position:
Turn the switch OFF and loosen the two
screws shown in figure-7 and move the
sanding arm to the desired position and
retighten the screws.
Figure-7 Loosening the screws
TEST RUN
Once you have assembled the machine
and verified that grinding wheel is secured
and belt is tensioned and tracking properly,
it is then time to do a test run and see that
the machine powers up and runs properly.
All the tools and objects used for
assembling the machine should be
removed and cleared away during test run.
During the test run make sure the start/stop
button and all the safety features on the
machine are working properly.
Connect the machine to the correct power
source. Stand to the side of the grinding
wheel and start the machine. During the
test run if there is any unusual noise or
vibration, disconnect the machine from the
power source immediately. Check all the
parts you have assembled, once again and
try to find out the problem.
WARNING
Do not make any adjustments while the
machine is running. Turn the machine
OFF and un-plug from the power source
before making any adjustments. Failure to
do so may cause serious personal injury.