Craftex CT056, Owner'S Manual, Page: 7 / 22

CT056 6” WOODWORKING JOINTER
Unpacking
Your Craftex CT056 Woodworking Jointer comes assembled with the exception
of the steel stand, the mounting of the motor and the installation of the knife
guard.
Carefully remove all packing material and recycle where possible.
Cleaning
A protective coating is applied to your CT056 to protect it from corrosion in
shipping. This material should be removed with a cloth and mineral spirits. When
clean and dry, a coat of paste wax
should be applied to the precision
ground surfaces to protect them from
further corrosion.
Assembly
The Dust Chute doubles as a motor
mount and must be fastened to the
front and rear panels with the nuts,
bolts and washers provided. Do not
tighten the fasteners until the entire
base is sitting on a level surface.
Attach the left end panel so that the
dust chute is positioned in the
opening.
Attach the right end panel.
When you are satisfied that the base
is level, tighten all nuts and bolts
securely.
Please refer to page 16 for
numerical order of base
assembly
7