Craftex CT015N, Operating Instructions Manual

Page: 15 / 35

15
STEP FOUR:
PULLEYS AND BELTS
Parts required (with part#):
Qty: Tools required:
160:
motor pulley 1 Rubber mallet
164: pulley shaft bracket knob- 3 14mm wrench
screws 14mm wrench socket
157: pulley shaft bracket 1
158: main pulley drive 1
162: lower pulley drive 1
159A: small drive belt 1
161A: large drive belt 1
1. Remove the tape from the motor drive shaft. Don’t lose the key from the shaft;
remove it and put it to one side for now.
2. Insert the motor pulley (part #160) onto the
motor drive shaft, with the setscrew to the
inside. Gently tap the pulley onto the shaft
using a rubber mallet. Tap in the key. Further
tap in the pulley until it is flush with the end of
the shaft. Further tap in the key until it is flush
with the end of the shaft.
3. Open the unit and loosely attach the pulley
shaft bracket (#157) from the inside with the
knob-screws (#164) and Allen key. They will
be tightened up later in #10, below.