Craftex B318N, Owner'S Manual, Page: 7 / 13

Assembly Continued
Horizontal to vertical Position
1.
With the use of a # 13 open end
wrench loosen the nuts located in
Fig. (4).
2. The nuts are located in the back
of the disc.
3. You can now raise or lower the
position of the belt.
4. When you have the belt in the
position required tighten the nuts
and you are ready to resume your
work.
Fig. 4
Operation
•
Sanding belt and sanding disc are suitable for use on materials such as
metal, wood or plastic.
•
The work piece should be moved back and forth over the sanding belt to
maintain even belt wear and eliminate grooving.
•
Use the work support to back up the work piece. If the work piece is longer
than the belt surface remove the work support to allow full use of the belt.
•
A danger when sanding very soft wood is “ over sanding” and wood should be
sanded with the grain.
•
Excess pressure against the belt is not necessary. Do not push the sanding
operation, it will result in stalling the belt, clogging the abrasive, burning the
wood, or even tearing the belt.
7