9
ALIGNING THE ALIGN-A-RIP FENCE
The Align-A-Rip fence should now be aligned and this is best done before further
assembly, however, a 10” saw blade should now be installed.
Select the type of saw blade that you will be using on a continual basis.
(Disconnect the machine from the power source)
Loosen the screw on the table insert with a phillips
screwdriver and set the insert to one side.
Your CRAFTEX table saw comes complete with 2 double-
ended blade wrenches. One end is for the arbor nut while the other fits
over the arbor and engages in slots that will lock the arbor.
Raise the saw arbor to its highest point
Engage the arbor lock and using the wrench, remove the blade bolt and
washer.
Install the blade, the washer (with the flat side facing the saw blade) and arbor
nut and tighten. DO NOT OVER-TIGHTEN.
Replace the saw table blade insert a make the screw only snug and sitting
just
below the surface. Set the saw bevel to ‘0’ so that the blade is vertical and lock
the bevel with the lever above the blade height wheel. Raise the blade.
Slide the Align-A-Rip fence over to the right of the saw blade
and check the fence cursor to the left of the fence. The cursor
line should be at the ‘0’ mark or first line of the right side of the
scale. To adjust the front fence rail use a rubber mallet to ‘tap’
the rail assembly either left or right until this is attained. The
rear fence rail should be similarly adjusted.
When the fence is tight to the saw blade and the left cursor is at ‘0’, the rear
fence should be “squared” with the front fence.
Lock the fence down by pushing down on the fence-locking lever.
Now you may tighten all of the nuts supporting the front and rear fence rails
including the auxiliary support/tool shelf. Tighten the machine screws and nuts on
the hangers as well.
Summary of Contents for B2397
