Crafco SS60-Diesel, Manual

Page: 82 / 119

Super Shot 60 Diesel Melter Part Manual
Chapter 8 Troubleshooting
©2016 by Crafco, Inc. All Rights Reserved
………………...………………………………..……………...Troubleshooting 8-34
Table 8-30 Pump Electrical Troubleshooting (continued)
Step Possible Cause If . . .
10d Is there 12 Vdc between the "Mixer" toggle
switch center post red wire and the blue (4) wires
ground din plug?

Yes, check for a broken wire or poor wire
crimp on the red wire between the "Mixer"
toggle switch and the "Pump" toggle
switch.

No, if this is the case you would have had
an agitator problem. Call Crafco, Inc. and
speak to a service technician.
10e
Unscrew the din plug center screw so you can
pull the din plug up about 1/4", so you can check
for voltage. Is there 12 Vdc from side post to side
post, when the wand trigger is pulled?

Yes, the electrical system for the agitator is
working properly; go to Table 8-31 Pump
Hydraulic Troubleshooting .

No, recheck the amber light, if the light comes
"ON" and you do not have 12 Vdc then
replace the din plug.