©2016 Cradlepoint. All Rights Reserved.
|
+1.855.813.3385
|
cradlepoint.com
38
User Manual
/
IBR350
5/6/16
Home Agent IP Address
,
Home Agent Password
, and
Home Agent SPI
– Your home agent will be defined by your
NEMO service provider.
Renew Registration
– The NEMO network regularly re-registers with the home agent (e.g., every 30 seconds).
Specify the number of seconds between each check-in.
MTU
– Override the maximum transmission unit (
) of the NEMO tunnel. The TCP
(maximum segment
size) is automatically derived from the MTU. Leave blank to rely on
ROUTING
STATIC ROUTES
Add a new static route to the IP routing table or edit/remove an existing route.
Static routes are used in networks with more than one layer, such as when there
is a network within a network so that packet destinations are hidden behind an
additional router. Adding a static route is a way of telling the router about an
additional step that packets will need to take to reach their destination.
Click
Add
to create a new static route.
IP Version
: Select IPv4 or IPv6. Depending on your selection, you have different options for defining the
address range.
IP/Network Address
or
IPv6 Address
: The IP address of the
target network or host. The IPv6 address field includes
to declare a range of addresses.
Netmask/Prefix
: The Netmask, along with the IPv4 address,
defines the network the computer belongs to and which
other IP addresses the computer can see in the same
LAN. An IP address of 192.168.0.1 along with a Netmask
of 255.255.255.0 defines a network with 256 available IP
addresses from 192.168.0.0 to 192.168.0.255.
Gateway
or
IPv6 Gateway
: Specifies the next hop to be taken
if this route is used. A gateway of 0.0.0.0 implies there is no
next hop, and the IP address matched is directly connected to
the router on the interface specified:
LAN
or
WAN
.
Device
: Select the network interface from the dropdown
menu (e.g. ethernet-wan). You can use this instead of defining the IP address, especially in cases when the IP
address is changing.
Metric
: Set the numerical priority of the route. Lower numbers have higher priority.
Allow Network Access
: (Default: Deselected.) Some static routes will need an IP Filter Rule via the Firewall
to allow packets through the route without being blocked. Selecting this option automatically creates this IP
Filter Rule. If the
IP/Network Address
falls outside the LAN IP range, you probably need to select this option.
