
Power Cable:
25’ (7,6m)
Pump
Pool Cover
Evacuation
Hose
Power Cable:
25’ (7,6m)
Pump
Evacuation
Hose
Maximum
Immersion
Depth: 16’ (5m)
• Risk of electrical shock, if instructions are not followed.
• Always unplug the pump from its power source before installing, removing or servicing.
• Connect only to a grounded GFCI outlet that is a minimum of 10 feet (3 m) away from the pool.
DO NOT USE EXTENSION CORDS.
• This pump is intended to pump
WATER ONLY
. It cannot be used to pump oils, solvents or gasoline.
• Do not let children use this device unsupervised.
• Do not leave pump in water that may freeze as this will permanently damage the pump.
WARNING
Operating
Instructions
Cleaning Instructions
REMOVE AND CLEAN FILTER PAD AFTER EACH USE.
From the underside of the pump REMOVE:
1)
Motor cover
2)
Motor
3)
Filter pad.
Clean filter pad with water.
Replace filter pad, motor,
and cover.
Place pump on cover. Plug pump into a grounded GFCI
outlet. When water level reaches desired depth
(NOTE: pump
will turn off automatically when level of water is too low)
, unplug
pump and remove from cover.
AFTER EACH USE: Remove
and drain garden hose.
Remove and clean filter pad.
• Rated power: 1/3 HP
• Max. pump rate:
800 gallons/hour
• Standard garden hose
connection
• 7” wide stabilizing base
• Includes: 25’ cable,
reusable filter pad.
Attach a STANDARD GARDEN HOSE
to the pump.
1)
2)
3)
Motor
Cover
Underside of
Pump
Underside of
Pump
Motor
Filter Pad
Direct the other end of the
garden hose away from
the pool.
STEP 1
STEP 2
TO REMOVE WATER FROM POOL COVER
STEP 2
TO LOWER WATER LEVEL OF POOL
Submerge pump. Plug pump into a grounded GFCI outlet.
When water level reaches desired depth, unplug pump
and remove from pool.
TURNS
ON
AND
OFF
AUTOMATICALLY
AUTO-SWITCH
ON
Detection Level
AUTO-SWITCH
OFF
Detection Level
By: Champlain Plastics Inc.
87 Pillsbury Road, Rouses Point, NY 12979
INS-PCW1-rev1
www.champlainplastics.com
10-2019
PCW1 Submersible/Cover Pump
Multi-Purpose with Automatic ON/OFF