4096-1000
CPI Satcom & Antenna Technologies
1.2M Ku-BAND SERIES 1122
13
STEP 3:
Fine Azimuth Adjustment: Once the target satellite is located, fine
adjustments in azimuth can be made by
loosening the three Locking Hex
Nuts
on the underside of the Canister
top plate of the Az/el Positioner
and the two hex nuts under the Azimuth Pivot Posts.
With this hardware loosened, adjustments in azimuth can be made by
turning the Azimuth Adjust Bolt at the back of the Az/El Positioner in either
direction. See Figure 3-3.
Note: Azimuth Adjust Rod is for adjustment only, it is not intended to
be part of the structural integrity of the assembly, therefore
“tightening” the Azimuth Adjust Bolt is not necessary.
STEP 4:
Peak the antenna signal by fine adjustments made in both Azimuth and
Elevation until the optimum signal is achieved.
STEP 5:
Securely tighten all hardware used for adjustment.
Figure 3-3
Locking Hex Nuts
(3 Places)
Azimuth Pivot Post
Hex Nuts
(2 Places)
Azimuth Adjust Bolt
