PROGRAMMING (EBR-MS-S2-4SM & 8SM ONLY)
1
Enter programming mode by pressing
the following sequence of buttons within
5 seconds.
2
Choose the scene number to program.
3
Choose the circuit ID this applies to (do
this even if the circuit ID is the same as the
scene number).
à
à
à
à
All LEDs will flash to indicate the scene
plate is in programming mode.
To confirm the selection press :
To confirm the selection press :
If you need to use numbers that can't be
entered with your switch (e.g. "10") you must
use the RAPID Front End application or
UNLCDHS programming handset.
4
Set the required light level for this
circuit
5
Repeat steps and 4 for all circuits
required.
To cancel the current values and revert
back to the stored setting, press:
à
6
To store the scene setting repeat step 1
above.
If no keys are pressed for more than 5
minutes, you automatically exit
programming mode and no changes are
saved.