CF357C-H, CF358C-H, CF557C-H, CF558C-H - I.I.D. PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
Page 11
1.
Turn thermostat to it’s lowest setting.
2.
Turn off all electric power to the appliance if
service is to be performed.
3.
Remove lower front panel.
4.
Push in gas control knob slightly and turn clockwise
to “OFF”. Do not force.
5.
Replace lower front panel.
PN 91214 02/05
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
B.
BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electric switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire
department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified service
technician. Force or attempted repair may result in a fire
or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the control
system and any gas control which has been under water.
PN 91214 02/05
NOTE: Knob
cannot be
turned to
“OFF” unless
knob is pushed
in slightly. Do
not force.
Gas Control Knob
1.
STOP! Read the information on the safety label.
2.
Set thermostat to lowest setting.
3.
Turn off all electric power to the appliance.
4.
This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to
light the pilot by hand.
5.
Remove lower front panel.
6.
Push in gas control knob slightly and turn clockwise
to “OFF”.
9.
Replace lower front panel.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions
“TO TURN OFF GAS TO APPLIANCE” and call your
service technician or gas supplier.
PN 91214 02/05
GAS CONTROL
KNOB
7.
Wait five (5) minutes to clear out any gas. Then smell for
gas, including near the floor. If you smell gas, STOP!
Follow “B” in the information on the safety label. If you
don’t smell gas, go to the next step.
8.
Turn gas control knob counterclockwise to “ON”.
