Coyote Point Systems Equalizer GX Series, Administration Manual

Page: 336 / 866

Working with Clusters and Match Rules
UDP Cluster Configuration Settings
The UDP Cluster
Configuration Settings
screen shown below is displayed automatically when the
cluster is added to the system, or by selecting the cluster from the left navigational pane on the
GUI and selecting the
Configuration Settings
tabs.
Protocol The protocol used for the cluster.
VID The VLAN ID number. This is an integer between 1 and 4095.
IP
Enter the IP address , which is the dotted decimal IP address of the
cluster.
Port
For TCP protocol clusters the numeric port number on the Equalizer to be
used for traffic between the clients and the cluster. For TCP clusters, the
port defaults to 80. This port also becomes the default port for servers
added to the cluster (though servers can use a different port number than
the one used by the cluster).
Preferred Peer
Used with N+1 Failover Configuration. Refer to
"Configuring N+1 Fail-
over Between Two EQ/OS 10 Systems"
on page 583
.
Server Pool
The drop down list selects the Server Pool (grouping of server instances)
to be associated with the TCP cluster.
Range
For L4 UDP and L4 TCP protocol clusters, a port Range can be defined by
entering a value higher than the L4 port configured for the cluster. This
range allows Equalizer users to create a single cluster to control the traffic
for multiple, contiguous ports.
336 Copyright © 2014 Coyote Point Systems, A Subsidiary of Fortinet, Inc.