COX a123, Owner'S Operation Manual

Page: 7 / 56

31 May 2013
Page 7
OWNERS MANUAL FOR MODELS A15713A & A15813A
A12808L 16.5HP Rear Bagger Catcher Assembly
1/ Clean tubes with emery paper. Place the
front frame with the short tubes in each corner
on a flat surface with the short tubes up.
2/ Fit the upper frame over the outward
leaning front frame short tubes. Note: The
two holes in the upper frame near the
bent corners must face inwards.
3/ Install the rear frame by inserting hook
side of rear frame into upper frame, opposite
side to tilt lever mount bracket.
4/ Insert hook side into lower frame. 5/ Fit the lower frame over the two short tubes of the
front frame which lean inwards. Note: Make sure
the two holes in the sides of the lower frame
6/ Ensure tilt lever is angled toward front
frame before fitting M8x20 screws and nyloc
nuts.
8/ Feed the bag over the assembled frame
with the plain plastic base against the lower
frame (bottom of the catcher).
9/ Turn catcher over then clip the bag onto
the front frame.
10/ Using a small soldering iron melt
through the mesh at the four bolt holes in
the upper frame to suit the handle bolts.
11 / Fit braces as shown.
12/ Place the catcher
cover over the assem-
bled bag and frame,
line up bolt holes.
Using the two M8x40
screws & nyloc nuts fit
one handle to the rear
of the catcher with the
handle holes facing
down and handle lean-
ing toward the rear.
13/ Using the two M8x20 screws
and nyloc nuts fit the other handle
to the front of the catcher with the
handle holes facing forward.
Tighten all four handle screws.
14/ Use the cable ties in the top &
bottom corners if necessary to close
any gaps which may occur between
the bag and frame.
15/ Install catcher onto the ma-
chine and adjust the mounting
brackets so the top front edge of
the catcher bag makes contact with
the top lip of the mounting panel
when the catcher is closed.